對于濟南卷簾門我們要小心呵護,就好像呵護我們自己一樣,這樣才能夠延長卷簾門的壽命,才能夠提高卷簾門的可用性。下面就由小編告訴你正確的卷簾門保養方法吧:

　　We need to take good care of Jinan roller shutter doors, just like taking care of ourselves, in order to extend their lifespan and improve their usability. Let me tell you the correct maintenance method for rolling shutter doors:

　　1、卷簾門安裝位置的上端應有可靠的防火設施,在卷簾門的卷筒下端做包箱或吊頂時必須設置可拆式活動蓋板,在卷簾門彈王下端必須預留500x500mm可拆檢修孔,以便于維修保養。

　　1. The upper end of the installation position of the rolling shutter door should have reliable fire prevention facilities. When making a package box or ceiling at the lower end of the rolling shutter door, a detachable movable cover plate must be installed. A 500x500mm detachable access hole must be reserved at the lower end of the rolling shutter door spring to facilitate maintenance.

　　2、卷簾門運行時如有發生較大抖動或異常聲音時應停機檢查,排除有礙門簾正常啟閉的雜物。

　　2. If there is significant shaking or abnormal noise during the operation of the rolling shutter door, the machine should be stopped for inspection to eliminate any debris that may hinder the normal opening and closing of the door curtain.

　　3、閘門門簾和易銹部位,應進行定期防腐、油漆及保養處理,禁止用重物、硬物沖擊門面。

　　3. Gate curtains and rust prone areas should undergo regular anti-corrosion, painting, and maintenance treatment. It is prohibited to use heavy or hard objects to impact the facade.

　　4、卷簾門底梁座上限位置必須與軸承架下端保持大于200mm的距離,以制動停止時不發生沖頂現象。

　　4. The upper limit position of the bottom beam seat of the rolling shutter door must be kept at a distance of more than 200mm from the lower end of the bearing frame to prevent the phenomenon of toppling when braking stops.

　　5、卷簾門在啟閉停止過程中,應具備隨位停止之功能,不應有停止而繼續下滑現象,如發生下滑距離大于50mm的情況出現,應立即對卷簾門控制電器和卷門機制動器進行仔細檢查修理,運行正常為止。

　　5. During the opening and closing process of the rolling shutter door, it should have the function of stopping according to the position, and there should be no further sliding phenomenon after stopping. If the sliding distance exceeds 50mm, the control electrical appliances and rolling shutter mechanism actuators of the rolling shutter door should be carefully inspected and repaired immediately, and normal operation should be stopped.

　　6、卷門機在運行、滑行、傳動等部位應定期檢查(少每年3次),并根據需要及時加油,以卷簾門的正常使用。

　　6. The rolling door machine should be regularly inspected (at least 3 times a year) during operation, sliding, transmission, and other parts, and refueled as needed to ensure the normal use of the rolling door.

　　7、卷簾門操作時,操作者必須站在能看到卷門運行狀態的位置進行操作,否則易發生意外而受損。

　　7. When operating the rolling shutter door, the operator must stand in a position where the operating status of the rolling shutter door can be seen, otherwise accidents may occur and damage may occur.

　　8、所有電動控制的卷簾門,啟閉運行方向必須與開關精指示相同,特別是在新接通電源試車或外來輸入電源變換相線時,應先使用手動裝置將門簾置于門洞高度1/2的位置,接通電源后試操作卷門啟閉,直到與指示相附,方可正常使用,否則損壞限位器,引起卷帝反卷或沖中頂?shù)榷斐蓳p失。

　　8. All electrically controlled rolling shutter doors must operate in the same direction as indicated by the switch, especially when testing with a new power supply or when changing the phase line of an external input power supply. The door curtain should be manually placed at half the height of the door opening, and the power supply should be turned on before attempting to open and close the rolling shutter door until it matches the indication before it can be used normally. Otherwise, the limiter may be damaged, causing the roller to roll back or hit the center top, resulting in losses.

　　9、卷簾門門簾和卷門機禁止與酸、堿性物溶液接觸,以防腐蝕門簾表面。

　　9. Roller shutter door curtains and door rolling machines must not come into contact with acidic or alkaline solutions to prevent corrosion of the door curtain surface.

　　本文由  濟南卷簾門 友情奉獻.更多有關的知識請點擊  http://www.kwy6.cn/   真誠的態度.為您提供為的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from Jinan Rolling Shutter Doors For more related knowledge, please click http://www.kwy6.cn/ Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.